Carbon Reinforcement Straps - Latonia, KY
To install these straps, we must first free the walls from dust and dirt by sanding them down and cleaning them. We then apply an initial layer of epoxy to the walls. Then, we adhere the strap over the epoxy and attach any ceiling brackets that are needed. Lastly, we re apply another layer of epoxy to ensure the system is secured to the fullest extent.
Basement Repair in Latonia, KY
After we adhered all the necessary straps, we then waterproofed the basement. The fresh concrete seen around the coves of this picture helps conceal our WaterGuard subfloor drains.
Structural Repair in Latonia, KY
The block walls in this basement were in the earliest stages of wall failure, (slight cracks and minimal movement) so we were able to use this specific system. For walls in the later stages of wall failure, we have to use more invasive procedures. This is partly why proper monitoring is crucial.
Bowing Walls in Latonia, KY
The easiest way to detect for lateral foundation movement is to get a 6 foot level and place it vertically up all walls. If the level is able to "rock back and forth" at any point, (not level vertically) there is probably some movement going on.
New Basement Repair System in Latonia, KY
Here is where we installed the sump pump. All the subfloor drains are pitched down towards it. Also, you can see that the CarbonArmor strap off to the left of the photo is very thin. It can be painted over or concealed with any type of wall system.

